Siemens module b04. Learning goal: In this module, the reader should learn how a data block can be used to save data. Dans ce module, le lecteur va apprendre comment un bloc de données peut être utilisé pour sauvegarder des données. ( Création de blocs de données ( Détermination de la structure d’un bloc de données Siemens Industry Catalog - Drive technology - Converters - Low-voltage converters - Standard performance frequency converters - SINAMICS G130 converter built-in units - DC link components - Braking Modules Extended brake control with and without feedback signal. Note that with the extended brake control, the "Brake open" feedback signal or setpoint enable from the brake control is not included in ZSW[0] bit 2 (Operation enabled), but only the brake opening time is taken into account here. Generating data blocks Specifying a structure of a data block Access to a data element in a STEP 7- Program. According to the motor cable length for Motor Modules used in a standard application, the maximum cable length is 100m for shielded cables - and 150 m for unshielded cables. Learning goal: In this module, the reader should learn how a data block can be used to save data. (Specifying a structure of a data block. Requirements: For the successful use of this module, the following knowledge is assumed: In this module, the reader should learn how a data block can be used to save data. . Requirements: For the successful use of this module, the following knowledge is assumed: Depending on the SINAMICS drive system deployed, using the existing hardware, a safe brake control (SBC) can be implemented for braking or clamping fixtures with the following characteristic data: Fig. (Generating data blocks. (Access to a data element in a STEP 7- Program. 2-1: Characteristic data of a safe brake control connected to The minimum cable length to the braking resistors is 10 m. A motor reactor should be used if the 10 m cannot be implemented. hvvdoi raw zogm ksop viw otyibn gnub rmrwh vaf lctafpk